Retrotouch Crystal Shaver Socket Guide

Crystal Shaver Socket

The Retrotouch Crystal Shaver Socket is designed to provide a safe and convenient power supply for electric shavers and toothbrush chargers in bathrooms. Featuring a premium glass finish with a screwless design, it complements modern bathroom interiors while meeting UK electrical safety requirements.

Key Features

• Premium crystal glass, screwless faceplate
• Dual voltage output: 110V / 230V
• Suitable for electric shavers and toothbrush chargers
• Ideal for bathrooms, en-suites and cloakrooms
• Modern design to match the Retrotouch Crystal range
• Easy installation by a qualified electrician

What Can It Be Used For?

The shaver socket is intended for low-power bathroom appliances, including:

• Electric shavers
• Electric toothbrush chargers
• Similar low-power grooming devices

Do not use the socket for:

• Hair dryers
• Hair straighteners
• Curling tongs
• Heated styling tools
• High-power appliances

These devices require a standard mains socket outside the bathroom or one installed in accordance with current electrical regulations.

Why Does It Have 110V and 230V?

The dual-voltage design allows compatibility with many UK and international shaver plugs, making it especially useful in guest bathrooms and hotels.

• 110V – Compatible with many international shaver plugs.
• 230V – Suitable for UK and European compatible shaver appliances.

The socket incorporates an isolation transformer to provide additional protection in bathroom environments.

Installation

Installation should only be carried out after isolating the mains supply.

Installation Steps

1. Turn off power at the consumer unit.
2. Remove the existing accessory.
3. Note existing wiring before disconnecting.
4. Connect the new shaver socket to the corresponding terminals.
5. Ensure all earth connections are correctly sleeved where required.
6. Tighten terminals securely without over-tightening.
7. Refit the unit and restore power.
8. Test the installation before use.

Installation must comply with the latest edition of BS 7671 (IET Wiring Regulations) and applicable Building Regulations. If you are unsure, always use a qualified electrician.

Safety Information

• For bathroom use only.
• Designed for low-power shaver and toothbrush charging equipment.
• Never overload the socket.
• Do not connect extension leads or adapters for high-power appliances.
• Always isolate the electrical supply before installation or maintenance.
• Keep the product clean using a soft, dry cloth.
• Do not use abrasive cleaners or solvents.

Frequently Asked Questions

Can I plug a hair dryer into this socket?

No. Shaver sockets are designed for low-power appliances only.

Can I charge my electric toothbrush?

Yes. Most UK toothbrush chargers with a shaver plug are suitable.

Can I use both outlets?

The socket automatically provides the correct voltage for compatible appliances. Always check your appliance voltage requirements before use.

Is professional installation recommended?

Yes. Retrotouch recommends installation by a qualified electrician in accordance with current wiring regulations.

Need Help?